Royal Centec Service Manual download pdf (Page 17)

4 Operation

4.1 Operational safety

4.2 Vacuum cleaning

1. Pull out the cord by the plug up to the yellow mark (Fig. 6/1).

2. Insert the mains plug into a socket with ground/safety contact.

3. Switch on the cylinder vacuum cleaner with the on/off switch (Fig. 6/4).

4. Adjust the suction power with the suction power control (Fig. 6/5).

5. If using the floor nozzle, set the "carpet/hard floor" selector according

to the type of floor to be cleaned (Fig. 7/1):

Fig. 7/A: for deep- and short-pile carpets, runners

Fig. 7/B: for hard floors such as laminate, tiles, PVC etc.

4.3 Switching off

1. Switch off the cylinder vacuum cleaner with the on/off switch (Fig. 6/4)

and pull the plug from the mains socket.

2. Keep the plug in your hand.

3. To retract the power cord, push the cord retracting button (Fig. 6/3).

4.4 Transport and storage

 Only carry the vacuum cleaner by its carrying-handle (Fig. 8/1).

 For storage you can park the telescopic tube on the vacuum cleaner by

inserting the parking-hook of the floor nozzle into the parking-bracket

(Fig. 8).

 If you want to store the appliance for a longer period of time, empty the

dust container. chapter 5.1, „Emptying and cleaning the dust container“.

 Store the appliance in a cool, dry place, out of reach of children.

WARNING:

Danger of injury! Check appliance and power cord before each use. A

damaged appliance must never be used.

WARNING:

Danger of injury! Especially when vacuum-cleaning stairs make sure

that you always stand on a higher level than the appliance.

ATTENTION:

Only use the cylinder vacuum cleaner with all filters intact, in dry condi-

tion and correctly fitted. Make sure that no objects obstruct the tele-

scopic tube, the suction hose or other openings.

NOTE:

Your cylinder vacuum cleaner is equipped with a safety switch to prevent

overheating. It will switch off automatically if overheated (e.g. due to

clogged suction channels).

If this happens:

 Switch off the vacuum cleaner.

 Pull the plug from the power socket.

 Remove the cause of the overheating.

 Wait for about 45 minutes.

After it has cooled off, you may switch on the vacuum cleaner again.

WARNING:

Danger of electric shock! If the red marking (Fig. 6/2) shows, press the

cord retracting button (Fig. 6/3) to pull in the cord up to the yellow mark

(Fig. 6/1) again. Otherwise, the power cord may be damaged.

NOTE:

With the bypass vent (Fig. 6/6) you can quickly reduce the suction power

if less power is needed, e.g. to release curtains accidentally sucked in.

WARNING:

Danger of injury! When leaving your working-area, switch off the appli-

ance and mind the notices at chapter 4.3, „Switching off“. This will help

avoid accidents.

WARNING:

Danger of injury! During uncontrolled retraction the power cord can whip

around, become an obstacle or overthrow objects. Therefore keep the

plug in your hand and guide it when retracting the power cord.

ATTENTION:

Never store the appliance next to heat sources (e.g. stoves or radiators).

Avoid exposing it to direct sunlight. Heat can damage the appliance.

Centec 2.book Seite 17 Mittwoch, 5. Juni 2013 5:50 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Comments to this Manuals

No comments

Royal Centec Service Manual Page 17

Comments to this Manuals

Related products and manuals for Vacuum cleaners Royal Centec