Royal Centec Service Manual download pdf (Page 19)

5 Maintenance

5.3 Cleaning the exhaust filter

 Clean the exhaust filters each time you clean the filter inserts, chapter

5.2, „Cleaning filter inserts“.

 However, clean the exhaust filter at least every six months.

1. Switch off the appliance , chapter 4.3, „Switching off“.

2. Push the release catches of the exhaust filter cover down (Fig. 13/A)

and fold down the exhaust filter cover.

3. Remove the exhaust filter from its holder (Fig. 13/B).

4. Hold the filter holder together with the exhaust filter in a dustbin and re-

move larger accumulations of dirt by hand.

5. Remove residual dust with a soft brush, e.g. the supplied furniture

brush (Fig. 14/A).

6. If the exhaust filter is damaged, deformed or too soiled, replace it (or-

dering information chapter 5.4, „Spare parts and accessories“).

7. Place the clean/new exhaust filter back into its holder (Fig. 13/B).

8. Fit the exhaust filter cover on the bottom side first (Fig. 14/A) and then

hinge it upwards (Fig. 14/B).

5.4 Spare parts and accessories

 Ordering address: Page 62, „International Service“

 The following accessories and spare parts can be reordered:

5.5 Troubleshooting

Before contacting your authorised Dirt Devil dealer or service partner or

sending in the appliance, first follow the procedure in the following table to

check if you can solve the problem yourself.

A B

click!click!click!

ATTENTION:

The exhaust filter cannot be washed.

ATTENTION:

Only use original spare parts from the scope of delivery or those that you

have acquired by reordering.

Item number Description

2288001 1 filter screen (Fig. 1/18) and

1 cyclone unit (Fig. 1/19)

2288002 2-piece filter set

(1 premotor filter [Fig. 1/10] and

1 protective motor filter [Fig. 1/17])

2288003 1 exhaust filter (Fig. 1/30)

M203 1 parquet brush (Fig. 2/4*)

M209 1 turbo brush (Fig. 2/5*)

WARNING:

Danger of injury! Never use a defective appliance! Always switch off the

appliance and disconnect it from the mains before starting troubleshoot-

ing chapter 4.3, „Switching off“.

Problem Possible cause / solution

The appli-

ance will not

start.

The socket does not carry current.

Test the vacuum cleaner at another socket which you are

sure carries current.

Power cord is damaged. Have the power cord replaced by

Dirt Devil Customer Service, address, Page 62,

„International Service“.

The vacuum

cleaner

stops sud-

denly.

The overheating protection has tripped (possibly due to

blocked suction channels, filters, or similar).

Switch the appliance off and pull the plug out of the socket.

Remove the cause of overheating (e.g. by disassembling

telescopic tube and suction hose and removing the obsta-

cle and/or cleaning filters). Wait for about 45 minutes. After

the appliance has cooled off, you may switch it on again.

Cleaning in-

dicator

(Fig. 1/26)

lights up.

The dust container is full.

Empty / clean the dust container, chapter 5.1, „Emptying

and cleaning the dust container“.

The filter inserts are dirty.

Clean the filter inserts, chapter 5.2, „Cleaning filter

inserts“.

The cleaning

results are

unsatisfacto-

ry in spite of

the appli-

ance work-

ing correctly.

The bypass vent (Fig. 1/9) is open.

Close the bypass vent .

The attached nozzle is unsuitable.

Change the nozzle, chapter 3.2, „Selecting the proper

nozzle“.

The suction power you set is unsuitable.

Adjust the suction power control to suit the flooring,

chapter 4.2, „Vacuum cleaning“, step 4.

The position of the "carpet/hard floor" selector (Fig. 1/5) is

unsuitable.

Set the "carpet/hard floor" selector to the correct position

for the type of floor, chapter 4.2, „Vacuum cleaning“,

step 5.

The dust container is full.

Empty / clean the dust container chapter 5.1, „Emptying

and cleaning the dust container“.

The filters are dirty.

Clean the respective filter or filter insert, chapter 5.2,

„Cleaning filter inserts“ or chapter 5.3, „Cleaning the

exhaust filter“.

Nozzle, telescopic tube or suction hose are blocked.

Remove the obstacle. If necessary, use a long wooden

stick (e.g. a broomstick) to do this.

NOTE:

If you cannot solve the problem following these instructions, contact the

Dirt Devil customer service (Page 62, „International Service“).

Problem Possible cause / solution

Centec 2.book Seite 19 Mittwoch, 5. Juni 2013 5:50 17

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 63 64

Comments to this Manuals

No comments

Royal Centec Service Manual Page 19

Comments to this Manuals

Related products and manuals for Vacuum cleaners Royal Centec